Table of Contents
Advertisement
Regular inspection/maintenance for the door and operator should be performed at regular
intervals to ensure the system runs at peak safety, performance and efficiency.
MAINTENANCE ITEM
Contact Reverse Test
Lubricate Door Hardware
Safe-T-Beam® system check
Door Balance
Battery Backup System
Remote Battery replacement As Needed
Light Bulb Replacement
Door Inspection
Perform the Door inspection as follows:
With the door closed, pull manual emergency release handle DOWN and away from door and let go to
disengage the carriage from the drive chain or belt. FIG.21.
• Raise and lower the door manually. Door should move freely and smoothly.
• Raise door manually about 3' to 4' from floor and let go. Door should remain stationary or slowly
drift closed. FIG. 22.
If door opens or closes rapidly, CONTACT A TRAINED DOOR SYSTEM TECHNICIAN to have your door
springs serviced.
• Close the door.
• Place the carriage in the "engage" position Reverse of FIG. 21.
• Operate door using remote or wall control. The carriage will reattach itself to the drive chain/belt.
WARNING
!
•
Garage door hardware (springs, cables, brackets, pulleys, etc.) are under
extreme pressure and tension.
•
DO NOT attempt to repair or adjust door springs or any hardware, and
DO NOT OPERATE garage door automatically or manually if door is
improperly balanced or springs are broken.
•
CONTACT A TRAINED DOOR SYSTEM TECHNICIAN.
Chain/Belt Drive
Disengage the carriage by pulling
the release handle straight down,
and then releasing
DO NOT use release cord to pull door!
MAINTENANCE
INTERVALS
Monthly
Monthly
Monthly
Monthly
Monthly
As Needed
FIG.21
DETAILS
See Page 27 to run system test.
Lubricate Rollers & Hinges with a light weight general
purpose grease.
Check wiring for loose connections, cracks or worn
insulation.
Clean lenses of dirt & debris.
See Door Inspection
Unplug operator from outlet. Test operator with
remote or wall console. Replace battery if needed.
See Replacing Batteries
See Changing Light Bulbs
AVERTISSEMENT
!
•
La quincaillerie de la porte de garage (ressorts, câbles, supports, poulies,
etc.) sont sous des pressions et des tensions extrêmes.
•
NE PAS réparer ni régler les ressorts de la porte ou toute autre pièce
de quincaillerie et NE PAS ACTIONNER la porte manuellement ou
automatiquement si elle n'est pas correctement équilibrée ou si des ressorts
sont cassés.
•
CONTACTEZ UN TECHNICIEN SPÉCIALISÉ EN SYSTÈME DE PORTES
FIG 22
37
Advertisement
Table of Contents
