Install Light Bulbs And Lens Cover - Genie GCL-LT Manual

INSTALL LIGHT BULBS AND LENS COVER

1. Install light bulbs into operator light sockets.
2. Insert lower lens tabs into slots in motor cover on operator.
3. Snap upper lens tabs into place.
NOTE: Aladdin Connect® models require a minimum 360 lumens LED bulb, 15 Watt maximum.
DO NOT exceed maximum wattage, as the unit may overheat and permanent damage may occur. Each light bulb
should be no more than 15W maximum.
Do not use halogen, short neck, or specialty light bulbs as they may overheat the operator.
NE PAS dépasser la puissance maximale, dans la mesure où l'unité peut surchauffer et des dommages
irréversibles peuvent se produire. Les ampoules ne doivent pas être supérieures à 15 W max.
Ne pas utiliser d'ampoules halogènes, au cou court ou de spécialité parce qu' e lles risquent de surchauffer
l' o uvre-porte.
Use only LED light bulbs with maximum 15 watts.
* Genie LED light bulbs are designed to reduce or
eliminate reduced remote range issues caused by
common LED bulbs. They also offer better product life
by making them resistant to vibration caused by the
operator, and cold or damp weather. See website for
details at www.GenieCompany.com
CAUTION
!
CAUTION
!
21