Transmitter Programming (If Applicable) - Genie GCL-LT Manual

TRANSMITTER PROGRAMMING (IF APPLICABLE)

NOTE: Each programming step has a 30 second time
limit for completion after the function is initiated. After
30 seconds, two LED's will illuminate RED indicating time
has expired and the step must be re-started. Restart
the step as many times as necessary to complete the
programming.
NOTE: Do not hold remote too close to the operator
when programming remote buttons.
NOTE: Each button on each remote must be programmed
separately, following these steps.
1. Remove the battery's protective film from
the remote by pulling straight down.
2. Press and hold the SET/PRGM button on
the operator for two seconds.
· The ROUND LED will turn BLUE.
· The LONG LED will then flash PURPLE.
3. Stand at least 5 feet away from operator
and slowly press and release the desired
button on the remote two times.
· Both operator LEDs will flash and
turn off indicating the remote has been
programmed.
4. Press the desired remote button again.
· The operator will run.
To program the same remote for other garage
door operators, repeat the steps above using one
of the other remaining remote buttons.
REPEAT STEPS 1 TO 4 FOR EACH OPERATOR
AND REMOTE
NOTE: It is possible to press the remote button too
quickly or lightly. If the LEDs do not go off, press
the remote button several more times to achieve
confirmation.
BASIC PROGRAMMING IS COMPLETE AND YOUR
GARAGE DOOR OPERATOR IS READY TO USE.
See PAGE 18 of this manual to erase remote
devices from memory.
28
1. Activate Remote
2. Enter Programming Mode
Solid Blue
Flashing
Purple
3. Press Remote Button Twice
Flashing
4. Test Remote
PRESS
&
RELEASE