Table of Contents
Advertisement
SPECIAL INSTALLATION INFORMATION
Adjusting Speed Control
Speed Settings (DC Models only)
Speed settings are pre-programmed at the factory for the maximum
speed. Speed settings should not need adjustment with this unit.
However, travel speed for the operator can be adjusted to a slower
speed in both the Open and Close directions, to minimize wear on
heavier sectional doors.
There are three speed settings available for sectional doors.
Please note that speed may be affected by door weight and balance,
along with condition of door components and tracks.
TO CHANGE OPERATOR TRAVEL SPEED:
1. Press and Hold the PRGM button.
· both LEDs turn BLUE, then release
2. Press the UP button twice.
3. Press PRGM button once.
· The current UP speed setting will now be displayed. (SEE CHART).
4. Press either UP or DOWN buttons to adjust speed (SEE CHART)
5. Press PGRM button once to lock in the UP travel speed.
· The current DOWN speed setting will now be displayed. (SEE CHART).
6. Press either UP or DOWN buttons to adjust Down Travel Speed (SEE
CHART).
7. Press PGRM button once to lock in the DOWN travel speed.
Operator is now ready to operate and test.
Operate door from the wall console two full cycles then perform
safety contact reverse test. (SEE PAGE 8)
SPEED SETTING CHART
Speed Level
HIGH
MED
LOW
Long LED
Round LED
RED
RED
PURPLE
PURPLE
BLUE
BLUE
1-3. Enter Speed Control Mode
PRGM
SET
BLUE
PRGM
SET
PRGM
SET
PRGM
SET
See Chart for Speed level
4. Press + & - Buttons
PRGM
SET
Press to adjust. See
Chart for Speed level
5. Press PRGM Button
PRGM
SET
Lock UP travel speed
PRGM
SET
See Chart for Speed level
6. Press + & - Buttons
PRGM
SET
Press to adjust. See
Chart for Speed level
7. Press PRGM Button
PRGM
SET
Lock DOWN travel speed
X2
35
Advertisement
Table of Contents
