Table of Contents
Advertisement
Programming UP Limit:
1. Press and hold the UP arrow button.
· Long LED will light BLUE.
2. Release UP arrow button.
· Round LED will flash BLUE.
3. Press and hold the UP arrow button until door
is fully open.
· Use the DOWN arrow button if door
opens too far. Use both UP and DOWN
buttons to adjust open travel as necessary.
NOTE: Door should fully open so that door seal is
even with door header. DO NOT adjust so much
that the door will bend or buckle or stretch door
spring cables backward.
4. Press and release the SET/PRGM button
· Both LEDs will flash BLUE then go out.
The UP limit is now programmed.
26
PROGRAMMING UP TRAVEL LIMIT
1-2. Enter Programming Mode
Steady Blue
PRGM
SET
Flashing
PRGM
Blue
SET
3. Adjust Door Position
PRGM
SET
4. Lock Programming
Flashing
PRGM
Blue
SET
PRGM
SET
HOLD
UNTIL
LED
Lights
RELEASE
PRESS
&
RELEASE
Advertisement
Table of Contents
