Cutter; Loading And Removing Paper With The Cutter; Installing The New Paper Roll - TransAct Ithaca 90PLUS Series Operator's Manual

36
Series 90PLUS Operator's Guide

CUTTER

LOADING AND REMOVING PAPER WITH THE CUTTER

INSTALLING THE NEW PAPER ROLL

The cutter is a factory installed option on the Series 90PLUS Printer. The
cutter performs a partial cut that slices the receipt paper when the receipt is
finished printing.
This section describes how to load and remove paper with the optional cutter
installed, if your printer does not have the optional cutter installed refer to
"Loading and Removing Paper" on page 27. Change the paper when the
READY light flashes orange and green. This indicates that the paper is low.
The printer will stop. You must change the paper for the printer to resume
operation.
Follow these instructions for loading either single- or multiple-ply paper.
Note: If this is a new installation, a receipt roll is supplied with the
printer.
If you are changing multiple-ply paper, remove the journal
take-up roll before loading the new roll. See "Removing the
Journal Take-up Roll" on page 40.
1. Open the paper cover.
If you are changing the paper, remove the used supply roll. Do not pull on
the paper to remove unused paper from the printer. Instead, hold the FEED
and the RESUME buttons simultaneously. This removes unused paper
from the printer safely.
2. Tear off a clean edge on the new roll, and fold the paper straight.
This makes it easier to load the paper.