Daikin Clima-Flex CLIC Series Installation, Operation And Maintenance Manual page 59

Unit Controller Operation
CONTROLLER INPUTS AND OUTPUTS
The configuration of the inputs and outputs depends on the initial configuration screen for the first time in this case the table shows the
assigned inputs and outputs of each configuration in this case when cold mode is selected the description code is CO AIR and when
heat mode is selected the description code is HP AIR.
Analog inputs of the MASTER unit
Table 8.
#
COLD AIR TYPE
DESCRIPTION
U1 INJECTION
U2 RETURN
U3 FREEZING
U4 GENERAL RETURN
U5 GENERAL INJECTION
U6 CONDENSER
TEMPERATURE
U7 RECOVERY
Digital inputs of the MASTER unit
Table 9.
#
DESCRIPTION COLD AIR TYPE
U9 N/A
ID1 HIGH PRESSURE
ID2 LOW PRESSURE
ID3 REMOTE ON/OFF
ID4 MOTOR PHASE DETECTOR
SAVER
Analog outputs of the MASTER unit
Table 10.
#
DESCRIPTION COLD AIR TYPE
Y1 INVERTER/SSR
Y1 INVERTER FAN
U3 FREEZING
www.clima-flex.com
DESCRIPTION HOT SIGNAL
AIR TYPE TYPE
INJECTION NTC
RETURN NTC
FREEZING NTC
GENERAL RETURN NTC
GENERAL NTC
INJECTION
CONDENSER NTC
TEMPERATURE
RECOVERY N/A
DESCRIPTION HOT AIR TYPE
SELECTOR
HIGH PRESSURE
LOW PRESSURE
REMOTE ON/OFF
MOTOR PHASE DETECTOR SAVER
DESCRIPTION HOT AIR TYPE
INVERTER/SSR
INVERTER FAN (NOT INCLUDED IN
ALL UNITS)
FREEZING
59
EXPECTED RANGE
NTC Thermistor R25=10KΩ +1% β25/85=3435K
+1% -discrete type (No SMD
NTC Thermistor R25=10KΩ +1% β25/85=3435K
+1% - discrete type (No SMD)
NTC Thermistor R25=10KΩ +1% β25/85=3435K
+1% - discrete type (No SMD)
NTC Thermistor R25=10KΩ +1% β25/85=3435K
+1% - discrete type (No SMD)
NTC Thermistor R25=10KΩ +1% β25/85=3435K
+1% - discrete type (No SMD)
NTC Thermistor R25=10KΩ +1% β25/85=3435K
+1% - discrete type (No SMD)
N/A
SIGNAL TYPE EXPECTED RANGE
DRY CONTACT
DRY CONTACT
DRY CONTACT
DRY CONTACT
DRY CONTACT
SIGNAL TYPE EXPECTED RANGE
VCD VOLTAGE
VDC VOLTAGE
NTC
N/A
N/A
N/A
N/A
N/A
0-10
0-10
345 A 300 kΩ
iom-clic-cf-eng