CDI CD52 Bandit User Manual page 33

CD52 Bandit (ATEX-IECEx and UKCA Certification) User Guide
1: Prep Banding
Prepare the band and buckle.
Slide the buckle over the band
and crimp in place.
NOTE: Banding material
and band tension tool
options are stocked by CDI.
(See pg. 38)
2: Attach Base
Set the base on the pipeline. Loop the free end of the band through the
slots at one end of the base.
Continue looping the free end
around the pipe until it meets
the buckle at the other end of
the band.
NOTE: The standard CD52
antenna base (shown here)
is of cast aluminum and must be
handled with care. Do not over-
torque bands.
If required, use electrical insulators (see pg. 38) to electrically isolate the
CD52 Bandit from the pipeline to prevent corrosion.
Slide the free end of the band
through the buckle.
Page 33 of 52
INSTALLATION