Table of Contents
Advertisement
The Bandit is now prepared to set the hour portion of the clock. To
change the hour, simply rotate the lever to the activate position and
hold it there. You should notice the BTN segment lights and the hour
digits begins to increase at a rate of one hour per second.
Continuing to hold the lever in the activated position will cause the
hours to increase until they reach "12", and then wrap to "1" (The
Bandit uses 12-hour, not 24-hour time).
Hold the lever in the activated position until the digit reaches the
desired hour and then release. The display will jump to the minute
portion of the time to set. The same method is used to set the
minutes. Simply press and hold the lever to increment the digits, and
release to move to the date.
Repeatedly pressing and releasing the lever while in clock set mode
causes the unit to cycle through the following clock set options:
1. HOURS
2. MINUTES
3. AM/PM
4. DAY
5. MONTH
Portable Models
The portable Bandit is designed for temporary location/relocation from
one tracking site to the next. It is identical to standard units in function
and operation, with two notable exceptions:
•
Battery power only
•
Suspend Mode push button
The Suspend Mode button is located on the back.
When pressed, all Bandit functions are paused to
prevent inadvertent triggering of the unit during
repositioning. The Active Function Indicator LCD (pg. 26)
will alternate between F1 and F2 every second.
CD52 Bandit (ATEX-IECEx and UKCA Certification) User Guide
To end the clock set mode, simply release
the lever. Normal Bandit operation will
return in twenty-five (25) seconds and
the clock will be set to the time indicated.
Page 31 of 52
SETUP AND OPERATION
Advertisement
Table of Contents
