Pc With Wi-Fi Adapter - D-Link DVG-5402G/GF User Manual

DVG-5402G/GF Wireless AC1200 Wave 2 MU-MIMO Dual
Band Gigabit Router with Fiber WAN Port, 3G/LTE Support,
2 FXS Ports, and USB Port
User Manual

PC with Wi-Fi Adapter

1. To connect the device to a fiber optic line: connect your SFP transceiver to the SFP port,
then connect the fiber optic cable to the SFP transceiver.
2. To connect via USB modem: connect your USB modem to the USB port
back panel of the router.
!
In some cases you will need to reboot the router after connection of the USB modem.
3. To connect the device to an Ethernet line: please connect the router to the ISP's Ethernet
line only after setting the WAN port (see the WAN Remapping section, page 227) and
creating an Internet connection (see the WAN section, page 83).
4. Connect a phone cable between an FXS port of the router and the phone.
5. Connect the power cord to the power connector port on the back panel of the router, then
plug the power adapter into an electrical outlet or power strip.
6. Turn on the router by pressing the ON/OFF button on its back panel.
7. Make sure that the Wi-Fi adapter of your PC is on. As a rule, modern notebooks with built-
in wireless NICs are equipped with a button or switch that turns on/off the wireless adapter
(refer to your PC documents). If your PC is equipped with a pluggable wireless NIC, install
the software provided with your Wi-Fi adapter.
Then make sure that your Wi-Fi adapter is configured to obtain an IP address automatically (as
DHCP client).
8 It is recommended to use a USB extension cable to connect a USB modem to the router.
Page 36 of 352
Installation and Connection
8 located on the