Table of Contents
Advertisement
Menu
Setting
Input Connector Name
Select Port
Flip Pattern
A.I.M.E.
PIP/POP Mode
Energy Saving Mode
Auto:
The format and scan mode are
displayed temporarily when the
content of Status Display is
changed.
On:
The format and scan mode are
always displayed.
Off:
The format and scan mode are not
displayed.
Notes
Even if "Status Display" is set to
"Auto" or "Off," the flip pattern is
always displayed.
For details about the signal format,
refer to no signal and non
compatible signal displays.
Input
No signal
Non compatible
signal (except for
DVI-D)
Non compatible
signal (DVI-D)
A.I.M.E. Display
On:
Always displayed while the A.I.M.E.
function is activated.
Off:
Not displayed.
Language
You can select the menu or message
language from the following
languages.
English: English
Italiano: Italian
Deutsch: German
Control Lock
Signal Format
Scan Size/
4K Zoom
Signal format
display
No Sync
Unknown
Out Of Range
: Chinese
: Japanese
: Spanish
: French
Menu
Setting
Power On Setting
Power On Mode
Select the setting when the monitor is
turned on from the following settings.
Logo
Select the logo display when the
power turns on, from "Off," "On -
5sec," or "On - 10sec."
A.I.M.E. Boot
Select the A.I.M.E. setting configured
when the monitor is turned on from
the following.
Power Save
Energy Saving
Select the energy saving mode from
Mode
the following options.
Sleep Mode
Sets the sleep mode to "Off" or "On."
When you set to "On," the monitor
enters into power saving mode by
turning off the backlight if there is no
input signal from the selected
connector for more than 1 minute.
Serial Remote
Serial Remote
Selects the using mode.
31
Last:
The setting when the monitor was
last turned off.
Default Setting:
The setting that is set in the default
setting.
User1 - 20:
The selected user setting.
Off:
The monitor is turned on with the
A.I.M.E. setting "Off."
Last:
The setting when the monitor was
last turned off.
Off:
Turns the energy saving mode off.
On:
Dims the backlight.
Off:
Inactivates the serial remote
function.
RS-232C:
Controls this unit via RS-232C
command.
Ethernet:
Controls this unit via Ethernet
command.
Advertisement
Table of Contents
