Table of Contents
Advertisement
4-6-4.
Input axis and addition/subtraction axis settings
This sets whether a 1 or 2-axis scale unit is connected. It also performs the addition/subtraction axis setting in the case of 2-axis
input.
The peak hold value is calculated using the axes selected here as the current value.
(Continued from 4-6-1 (2).) (P.133)
1. Select "Add" and press
ENTER
Selects whether the input axis is the 1st or 2nd axis only or
both the 1st and 2nd axes.
The selected item flashes.
"1"
: 1st axis only input
"2"
: 2nd axis only input
"12"
: 1st and 2nd axes input
The initial value is 1st and 2nd axis input (12).
2. Select the desired item with the cursor movement keys
.
• To enter the settings
3. Select the desired item and press
Enters the input axis and addition subtraction axis
settings.
(In this case, 1st axis only input (1) is selected.)
The setting contents light steadily for approximately
2 seconds for confirmation.
However, if "12" (1st and 2nd axes input) is selected,
the setting is not entered and operation shifts to the
addition/subtraction axis setting. (See the procedures
below.)
.
.
ENTER
Main display
Sub-display
Main display
Sub-display
(Lights)
(After approx. 2 sec.)
Main display
Sub-display
↓
141
Advertisement
Table of Contents
