Supported Transceivers; Fiber Channel Sfp+ Transceivers - Cisco MDS 9700 Series Hardware Installation Manual

Product Overview
11
The following table describes the power supply LEDs for the Cisco MDS 9700 Series.
Table 14: Cisco MDS 9700 Series Power Supply LEDs
LED
Input 1
Input 2
(available only
on DC power
supply units)
Output
Fault
ID

Supported Transceivers

The Cisco MDS 9710 Director supports the Fiber Channel SFP+ transceivers in Shortwave (SW), Longwave
(LW), Long Distance (CWDM and DWDM), or Extended Long Wavelength (ELW).

Fiber Channel SFP+ Transceivers

The transceivers are field-replaceable and hot-swappable. You can use any combination of SFP+ transceivers
that are supported by the switch. The only restrictions are that SW transceivers must be paired with SW
transceivers, and LW transceivers with LW transceivers, and the cable must not exceed the stipulated cable
length for reliable communications.
For more information about a specific Cisco SFP+ transceiver, see the SFP+ Transceiver Specifications
section. SFP+ transceivers can be ordered separately or with the Cisco MDS 9700 Series.
Note
ID power module LED
Status
Green
Off
Green
Off
Green
Off
Red, blinking (The blinking
stops when the fault
condition is cleared.)
Off
Blue, blinking
Off
Use only Cisco transceivers or Cisco qualified transceivers in the Cisco MDS 9700 Series. Each Cisco
transceiver is encoded with model information that enables the switch to verify that the transceiver meets the
requirements for the switch.
Description
The AC or DC input voltage is within the valid range.
The AC or DC input voltage is outside the valid range.
The DC input voltage is within the valid range.
The DC input voltage is outside the valid range.
The AC or DC output power is within the valid range.
The AC or DC output power is outside the valid range.
Self-diagnostic tests have failed or another power supply
failure has occurred.
The AC or DC output voltage and power supply unit tests are
okay.
The operator has activated this LED to identify this module
in the chassis.
This module is not being identified.
Cisco MDS 9700 Series Switches Hardware Installation Guide

Supported Transceivers

59