Supported Sfp+ Transceivers - Cisco MDS 9132T Installation Manual

Supported SFP+ Transceivers

Status
Intermittent flashing Green
Solid Orange
Flashing Orange
Off
Supported SFP+ Transceivers
SFP+ transceivers are field-replaceable. You can use any combination of SFP+ transceivers that are supported
by the switch. The only restrictions are that SWL transceivers must be paired with SWL transceivers on the
peer device, and LWL transceivers with LWL transceivers on the peer device, and the cable must not exceed
the stipulated cable length for reliable communications.
For the list of SFP+ transceivers supported on the Cisco MDS 9132T Switch, see the
Specifications
Note Use only Cisco SFP+ transceivers in the Cisco MDS 9132T switches. Each Cisco SFP+ transceiver is
encoded with model information that enables the switch to verify that the SFP+ transceiver meets the
requirements for the switch.
Cisco MDS 9132T Fibre Channel Switch Hardware Installation Guide
16
section. SFP+ transceivers can be ordered separately or with the Cisco MDS 9132T Switch.
State
The link is up (indicates traffic on the port).
The link is disabled by the software.
A faulty condition exists.
No link.
Product Overview
SFP Transceiver