Cisco MDS 9700 Series Hardware Installation Manual page 222

Accessory Kit Contents
Part Number
69-1815-XX
79-0087-XX
700-29059-01
78-21186-XX
78-17985-XX
Note
If you do not receive any part listed in this document, contact Cisco Technical Support at this URL:
http://www.cisco.com/warp/public/687/Directory/DirTAC.shtml. If you purchased this product through a
Cisco reseller, you may receive additional contents in your kit, such as documentation, hardware, and power
cables.
Each new switch ships with country-specific power cords—the shipped cords depend on your specification
when placing a Cisco MDS switch order. The available power cords for the Cisco MDS 9710 Director are as
follows:
• CAB-9K16A-AUS—power cord, 250-VAC 16-A, Src Plug A, Australia
• CAB-9K16A-CH—power cord 250-VAC 16-A, Src Plug GB16C, China
• CAB-9K16A-EU—power cord 250-VAC 16-A, Src Plug CEE, Europe
• CAB-9K16A-INT—power cord 250-VAC 16-A, Src Pl, International
• CAB-9K16A-ISR—power cord 250-VAC 16-A, Src Plug SI16, Israel
• CAB-9K16A-SA—power cord 250-VAC 16-A, Src Plug EL, South Africa
• CAB-9K16A-SW—power cord 250-VAC 16-A, Src Plug SEV 5, Switzerland
• CAB-9K16A-US1—power cord 250-VAC 16-A, Src Plug NE, US and Japan
• CAB-9K16A-US2—power cord 250-VAC 16-A, Src Plug NE, US and Japan
Cisco MDS 9700 Series Switches Hardware Installation Guide
208
Illustration
Not applicable
Not applicable
Accessory Kit Contents
Description
Ground lug kit (includes the following
parts)
Two-hole lug
M4 x 8-mm Phillips pan-head screws
ESD wrist strap
SFP Extractor
Product Documentation Pointer Card
China Management Methods Hazardous
Substances Content Table