Verification - Cisco MDS 9700 Series Hardware Installation Manual

Installing, Removing, and Verifying Field Replaceable Units
Command or Action

Verification

Use the show module xbar command to verify the module type and module status.
switch# show module xbar
Xbar Ports
---
1
2
3
4
5
6
Xbar Sw
---
1
2
3
4
5
6
Xbar MAC-Address(es)
---
1
2
3
4
5
6
To view the inventory information for modules from the Cisco DCNM Web UI, Choose Inventory > View
> Modules. The Modules window is displayed with a list of all the switches and its details for a selected
scope.
For more information, see the Cisco DCNM SAN Management Configuration Guide.
Module-Type
----- ----------------------------------- ------------------ ----------
0 Fabric Module 3
0 Fabric Module 3
0 Fabric Module 3
0 Fabric Module 3
0 Fabric Module 3
0 Fabric Module 3
Hw
--------------- ------
NA 1.0
NA 1.0
NA 1.0
NA 1.0
NA 1.0
NA 1.0
--------------------------------------
NA
NA
NA
NA
NA
NA
Purpose
j. Follow Step f to
Switching Module in slot 4.
k. Shut down the Crossbar Fabric-1 Switching Module in
slot 5, using the out-of-service xbar slot command.
l. Remove the fan module 3 over the Crossbar Fabric-1
Switching Modules in slots 5-6.
m. Physically remove and replace the Crossbar Fabric-1
Switching Module in slot 5 with a Crossbar Fabric-3
Switching Module.
n. Install the fan module 3 over the crossbar fabric
switching modules in slots 5-6.
o. Follow Step k to
Switching Module in slot 2.
Model
DS-X9710-FAB3
DS-X9710-FAB3
DS-X9710-FAB3
DS-X9710-FAB3
DS-X9710-FAB3
DS-X9710-FAB3
Serial-Num
----------
JAE1710088N
JAE2217096Y
JAE222305V1
JAE222305VE
JAE222305V9
JAE222305V8
Cisco MDS 9700 Series Switches Hardware Installation Guide
Verification
Step i to replace the Crossbar Fabric-1
Step n to replace the Crossbar Fabric-1
Status
ok
ok
ok
ok
ok
ok
167