Fiber Channel Over Ethernet Switching Modules - Cisco MDS 9700 Series Hardware Installation Manual

Fiber Channel over Ethernet Switching Modules

Table 11: Cisco MDS 9700 Series 24/10 Port SAN Extension Module LEDs
LED
Status
ID
Link
3

Fiber Channel over Ethernet Switching Modules

The following section describes the fiber channel over Ethernet switching modules.
Cisco MDS 9700 Series Switches Hardware Installation Guide
48
Status
Green
Orange
Blinking Red
Solid Red
Blinking blue
Off
Solid green
Steady Blinking
Green
Intermittent
Blinking Green
Solid Orange
Blinking Orange
3
Off
The Link LED status of IP Storage ports indicates Solid Orange when an SFP is present and the link is
not connected.
Description
All diagnostics pass. The module is operational (normal initialization
sequence).
One of the following occurs or occurred:
• The module is booting or running diagnostics (normal initialization
sequence).
• An over temperature condition has occurred. (A minor temperature
threshold has been exceeded during environmental monitoring.)
One of the following occurs:
• The module is resetting. The switch has just been powered on or
the module has been hot inserted during the normal initialization
sequence.
• An over temperature condition has occurred (a major temperature
threshold has been exceeded during environmental monitoring).
• If the module fails to download the code and configuration
information successfully during the initial reset, the LED stays
blinking red; the module does not come online.
The module has detected a slot ID parity error on the mid plane. The
module cannot determine its slot number and hence will not respond to
the Supervisor.
The operator has activated this LED to identify this module in the chassis.
This module is not being identified.
Link is up.
Port Beacon On (beacon is used to identify port).
Link is up (traffic on port).
SFP is not present or Admin is down.
A fault condition exists.
The port is not active or the link is not connected.
Product Overview