Supported Sfp+ Transceivers - Cisco MDS 9396S Hardware Installation Manual

Supported SFP+ Transceivers

Indicator
PSU Status
Indicators
Fan Status
Supported SFP+ Transceivers
SFP+ transceivers are field-replaceable. You can use any combination of SFP+ transceivers that are supported
by the switch. The only restrictions are that SWL transceivers must be paired with SWL transceivers, and
LWL transceivers with LWL transceivers, and the cable must not exceed the stipulated cable length for reliable
communications.
For the list of SFP+ transceivers supported on the Cisco MDS 9396S Switch, see the
Release Notes for Cisco MDS NX-OS Release
transceiver, see the
with the Cisco MDS 9396S Switch.
Use only Cisco SFP+ transceivers on the Cisco MDS 9396S switches. Each Cisco SFP+ transceiver is
Note
encoded with model information that enables the switch to verify that the SFP+ transceiver meets the
requirements for the switch.
Cisco MDS 9396S Multilayer Fabric Switch Hardware Installation Guide
14
Location Color
Faceplate of each Green
PSU
Amber
Faceplate of each Green
Fan Module
Amber
Red
SFP Transceiver Specifications
Status State
Off No input to the PSU.
Solid on PSU output is OK.
Blinking PSU output is not OK, but input
is OK.
Solid on Any of the following conditions
exists in the PSU:
Over voltage
Over current
Over temperature
Fan failure.
Blinking PSU has a fault, but is still
operating.
Off PSU is operating normally.
Solid on Fan module is operating normally.
Solid on One fan in the fan module has
failed.
Solid on Both fans in the fan module have
failed.
6.2(13). For more information about a specific Cisco SFP+
section. SFP+ transceivers can be ordered separately or
Product Overview
Cisco MDS 9000 Family