Cisco MDS 9700 Series Hardware Installation Manual page 174

Installing a Crossbar Fabric Switching Module
Figure 49: Inserting the Fabric Module into the Chassis
1
2
3
d. With your face away from the fabric module, press both ejector buttons on the front of the module.
Keep your face at least 12 inches (30 cm) from the front of the fabric module so that the ejector handles
Caution
do not hit your face when they spring out from the front of the module.
Both ejector handles spring out from the front of the module (see Callout 2 in the previous figure).
e. Grasp both handles, fully rotate the levers 90 degrees from the front of the module, and push the module all the way
into the slot until it seats.
The front of the module will be about 1/4 inch out from the installed fabric modules.
f. Simultaneously rotate both handles to the front of the module while pressing the module further into the slot (see
Callout 1 in the following figure).
The handles click when fully rotated to the front of the module.
Cisco MDS 9700 Series Switches Hardware Installation Guide
160
Align the module with the guides in the open slot and push the module half way into the slot.
Press both eject buttons.
Handles spring out from the module.
Installing, Removing, and Verifying Field Replaceable Units