Module Status Verification; Chapter 6 Configuring Ip Storage - Cisco MDS 9000 series Configuration Manual

Services Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o f m - d o c f e e d b a c k @ c i s c o . c o m
•
Figure 6-1
•
Figure 6-2
iqn.host-2
iSCSI
iqn.host-1
iSCSI

Module Status Verification

After inserting the module, verify the status of the module using the show module command:
switch# show module
Mod
---
Cisco Fabric Manager IP Services Configuration Guide
6-2
FCIP—FCIP transports Fibre Channel frames transparently over an IP network between two Cisco
MDS 9000 Family switches or other FCIP standards-compliant devices.
IPS module is used in different FCIP scenarios.
FCIP Scenarios
FC
Fabric
IP
network
FC
Fabric
iSCSI—The IPS module provides IP hosts access to Fibre Channel storage devices. The IP host
sends SCSI commands encapsulated in iSCSI protocol data units (PDUs) to a Cisco MDS 9000
Family switch IPS port over a TCP/IP connection. At this point, the commands are routed from an
IP network into a Fibre Channel network and forwarded to the intended target.
the iSCSI scenarios in which the IPS module is used.
iSCSI Scenarios
IP
IP-10.1.1.1
network
pWWW - P1
Ports Module-Type
----- -------------------------------- ------------------ ------------
"Control" TCP
connection
"Data" TCP
connection
FC
Fabric
FC
pWWW - P3
Fibre
channel
fabric
Model
Chapter 6 Configuring IP Storage
Figure 6-1 shows how the
Figure 6-2
pWWW - P2
Status
OL-19524-01,Cisco MDS NX-OS Release 4.2(1)
depicts