Reset Meter To Factory Defaults - Bindicator PRD1000 Instruction Manual

PRD1000 Analog Input Process Meter

Reset Meter to Factory Defaults

When the parameters have been changed in a way that is difficult to
determine what's happening, it might be better to start the setup
process from the factory defaults.
Instructions to load factory defaults:
1. Enter the Advanced Features menu. See Advanced Features
Menu , page 63.
2. Press Up arrow to go to Diagnostics menu
3. Press and hold Right arrow for three seconds, press
Enter when display flashes reset .
Note: If Enter is not pressed within three seconds, the display
returns to the Diagnostics menu.
4. The meter goes through an initialization sequence (similar as on
power-up), and loads the factory default settings.
Note: The dual-scale selection for some level applications (d-SCAL) is
not reset to the single scale factory default. This can be changed
using the Setup – Input menu.
81
Instruction Manual