PRD1000 Analog Input Process Meter
The meter is capable of accepting any voltage from -10 VDC to +10 VDC.
Modbus RTU Serial Communications
Serial communications connection is made to an RJ45 connector
labeled M-LINK on Figure 7. For interfacing to the PRD1000, use a
RS-485 serial adapter.
Relay Connections
Relay connections are made to two six-terminal connectors labeled
RELAY1 – RELAY2 on Figure 7. Each relay's C terminal is common
only to the normally open (NO) and normally closed (NC) contacts of the
corresponding relay. The relays' C terminals should not be confused
with the COM (common) terminal of the INPUT SIGNAL connector.
Figure 11. Voltage Input Connections
RELAY2
6
5
NO
NC
Figure 12. Relay Connections
RELAY1
4
3
2
1
C
NO
NC
C
22
Instruction Manual