Table of Contents
Advertisement
PRD1000 Analog Input Process Meter
Configuration for 12 or 24 VDC Power Option
Do not exceed voltage rating of the selected
configuration.
Warning!
Meters equipped with the 12/24 VDC power option are shipped
from the factory ready to operate from 24 VDC.
To configure the meter for 12 VDC power:
1.
Remove all the connectors.
2.
Unscrew the back cover.
3.
Slide the back cover about 1 inch.
4.
Configure the J9 jumper, located behind the power
connector, for 12 V as shown below.
M-LINK
24 VDC
12 VDC
POWER
Figure 5. Jumper Configuration for 12/24 VDC Power
MAIN BOARD
+
J9
_
J9 CONFIGURATION
24 V
12 V
18
Instruction Manual
Factory
Default
Advertisement
Table of Contents
Troubleshooting
