True C400E-9 Owner's Manual page 16

CHAPTER 2: ASSEMBLY INSTRUCTIONS
ELLIPTICAL ASSEMBLY STEPS (continued):
STEP 2: Attach Draw bar:
a)
Slide the top of the draw bars onto the exposed shaft. Figure 9
b)
Use the bolt and washer from bag 2 to secure the push rod to the shaft.
c)
Attach the bottom of the draw bars to rear crank with M8 x 12mm bolts. Figure 10
d)
Attach inside and outside Draw Bar Covers with remaining bolts. Figure 11
NOTE: Draw bars and covers are labeled left and right
Make sure to use the
washer in-between
the bolt and bearing.
Figure 9
Truefitness.com / 800.426.6570 / 636.272.7100
Figure 11
Figure 10
12