Instructions On The Connection Of Tb1 (Connector For Remote Control) - Matsusada Precision VOL Series Instruction Manual

２ - ７ - ３ Instructions on the connection of TB1 (connector for remote control)
This power supply generates a large amount of current. Running a large amount of current through
！
TB1 by connecting it in a wrong way may damage the control circuit.
CAUTION
Be sure to follow the instructions below:
Wiring with following pins must be short (less than several meters), and kept away from large noise
NO
source.
It might cause malfunction or failure.
TB1 PIN 1, 2, 3, 5, 7, 9, 10, 14, 15, 21, 22
(NOTE:)In case above condition cannot be obtained, combination of –LGob (GP-IB/RS232C,
Interface board) is recommended.
NO
Do not connect pin5 or 10 of TB1 to –output.
10 5 TB1
NO
Do not connect power supplies in series to connect
the commons of the control voltage.
TB1
LOAD
TB1
17
２ Installation and Operation
10 5 2 1
10
5 2 1
MATSUSADA Precision Inc.
LOAD