Table of Contents
Advertisement
VI. OPERATION INSTRUCTIONS
Please read the safety tips carefully before operating the lift
To lift vehicle
1. Keep the lift area clean and free of clutter;
2. Position lift arms to the lowest position, on floor;
3. Open or swing lift arms away from center of lift;
4. Position vehicle between columns;
5. Move or swing arms to the vehicle's lifting points;
NOTE: The four lift arms must make contact at the same time with the
vehicle's lifting and both axles must rise off the ground at the same time
6. Push "UP" button until the lift pads contact underside of vehicle. Raise vehicle just
enough that the wheels are off the floor. Recheck to make sure vehicle is secure.
7. Continue to raise the lift slowly to the desired working height.
8. Push lowering handle to lower lift onto the nearest safety lock. The vehicle is ready
to repair.
NOTE: The lift must always be on the safety locks when holding a vehicle.
To lower vehicle
1. Keep the lift area clean and free of clutter.
2. Push "UP" button to raise the vehicle slightly, and then pull the safety lock handle
to release the safety locks, lower vehicle by depressing the power unit lowering
handle.
3. Lower the vehicle completely to the floor, until arms no longer contact the vehicle.
4. Open the arms and position them to the shortest length.
5. Drive the vehicle out of the lift.
36
Advertisement
Table of Contents
