Xcc Wlan Configuration; Enable Xcc Wlan; Country / Region; Connect To Wlan - Lenovo ThinkEdge SE360 V2 System Configuration Manual

Note: If you use the backup SED AK file to restore a configuration, the system will ask for the password that
you set here.
Recover the SED AK
• Recover SED AK using Passphrase: Use the password that was set in Generate key using Passphrase
to recover the SED AK.
• Recover SED AK from Backup file: Upload the backup file generated in Backup the SED AK mode and
enter the corresponding backup file password to recover the SED AK.
• Recover SED AK from Automatic backup: After system board replacement, use automatic backup to
recover the SED AK for the installed SED.
Note: To recover the SED AK from automatic backup, the role of XCC user should be Administrator+.

XCC WLAN configuration

Use the following information to configure XCC WLAN.
SE360 V2 with wireless module supports XCC WLAN. XCC WLAN works in STA mode and the features can
be configured in Lenovo XClarity Controller.
Log in to Lenovo XClarity Controller web interface, and go to BMC Configuration ➙ Network ➙ WLAN to
configure XCC WLAN.
Notes:
• Before connecting XCC to WLAN, XCC WLAN feature should be enabled in Lenovo XClarity Controller
with wired network connection. To set the wired network connection for XCC, see
connection for the Lenovo XClarity
• The supported security type of WLAN varies by security mode. A warning window will be shown for
attempts on establishing WLAN connection with unsupported security type. For more information of
security mode, see https://pubs.lenovo.com/xcc2/NN1ia_c_securitymode.

Enable XCC WLAN

XCC WLAN is disabled by default. Click Disabled in the WLAN section to enable XCC WLAN.
After the status changing to Enabled, the available WLAN will be scanned and listed.

Country / Region

To comply with local regulations, make sure that the value is consistent with the location.

Connect to WLAN

Connect to available WLAN in the list
1. Select the WLAN in the list and click it.
Note: The Auto connect checkbox is checked by default. If the WLAN connection is successfully
established with the checkbox checked, the connected WLAN will be saved; XCC WLAN will connect to
the saved WLAN automatically. See
WLAN.
2. Select Security type. The field below might change according to the selected security type.
ThinkEdge SE360 V2 System Configuration Guide
72
Controller.
"Manage auto-connect" on page 74
Set the network
to manage the list of saved