Front Operator Panel Leds - Lenovo ThinkEdge SE360 V2 System Configuration Manual

Figure 15. Drive LEDs
LED Description
Drive activity Each hot-swap drive comes with an activity LED. When this LED is flashing, it indicates that the
1
LED (green)
drive is in use.
Drive status The drive status LED indicates the following status:
2
LED (yellow)
• The LED is lit: the drive has failed.
• The LED is flashing slowly (once per second): the drive is being rebuilt.
• The LED is flashing rapidly (three times per second): the drive is being identified.

Front operator panel LEDs

The front operator panel of the server provides controls and LEDs.
Figure 16. Front operator panel LEDs
Table 11. Front operator panel LEDs
"Power button with power status LED (green)" on page
1
35
"System ID button with system ID LED (blue)" on page
2
36
"Bluetooth button with LED (blue)" on page 36
3
"System Error LED (yellow)" on page 36
4
1 Power button with power status LED (green)
You can press the power button to power on the server when you finish setting up the server. You also can
hold the power button for several seconds to power off the server if you cannot shut down the server from
the operating system. The states of the power LED are as follows:
"Security LED (green)" on page 36
5
"XCC WLAN activity LED (green)" on page 37
6
"x86 WLAN activity LED (green)" on page 37
7
"NMI button" on page 37
8
Chapter 2
.
Server components
35