System-Board Leds - Lenovo ThinkEdge SE360 V2 System Configuration Manual

Status
On
Off
System ID LED (blue)
6
Use the system ID button and the blue system ID LED to visually locate the server. Each time you press the
system ID button, the state of the system ID LED changes. The LED can be changed to on, blinking, or off.
You can also use the Lenovo XClarity Controller or a remote management program to change the state of the
system ID LED to assist in visually locating the server among other servers.
7 Power status LED (green)
You can press the power button to power on the server when you finish setting up the server. You also can
hold the power button for several seconds to power off the server if you cannot shut down the server from
the operating system. The states of the power LED are as follows:
Status
Off
Flashing rapidly (four
times per second)
Flashing slowly (once
per second)
Lit

System-board LEDs

The following illustrations show the light-emitting diodes (LEDs) on the system board.
ThinkEdge SE360 V2 System Configuration Guide
40
Color Description
Blue Bluetooth is enabled.
None Bluetooth is disabled, or the server does not come with Bluetooth.
System ID button with system ID LED (blue)
13
12 Power button with power status LED (green)
Color Description
None No power supply is properly installed, or the LED itself has failed.
Green The server is turned off and is not ready to be turned on. The power button is
disabled. This will last approximately 5 to 10 seconds.
Green The server is turned off and is ready to be turned on. You can press the power
button to turn on the server.
Green The server is turned on.