Lenovo ThinkEdge SE360 V2 System Configuration Manual page 44

Status
Off
Flashing rapidly (four
times per second)
Flashing slowly (once
per second)
Lit
2 System ID button with system ID LED (blue)
Use the system ID button and the blue system ID LED to visually locate the server. Each time you press the
system ID button, the state of the system ID LED changes. The LED can be changed to on, blinking, or off.
You can also use the Lenovo XClarity Controller or a remote management program to change the state of the
system ID LED to assist in visually locating the server among other servers.
3 Bluetooth button with LED (blue)
Press the Bluetooth button to enable Bluetooth. After the Bluetooth button is pressed, if SE360 V2 does not
pair with any Bluetooth devices within 10 minutes, Bluetooth will be disabled automatically. Identify the
status of Bluetooth with the Bluetooth LED.
Status
On
Off
4 System Error LED (yellow)
The system error LED helps you to determine if there are any system errors.
Status Color
On Yellow
Off None
5 Security LED (green)
The states of security LED are as following:
Solid on: The server is operating with security feature enabled.
Blinking: The server is in System Lockdown Mode. Activate or unlock the system for operation. See
"Activate or unlock the system" on page
ThinkEdge SE360 V2 System Configuration Guide
36
Color Description
None No power supply is properly installed, or the LED itself has failed.
Green The server is turned off and is not ready to be turned on. The power button is
disabled. This will last approximately 5 to 10 seconds.
Green The server is turned off and is ready to be turned on. You can press the power
button to turn on the server.
Green The server is turned on.
Description
Color
Blue Bluetooth is enabled.
None Bluetooth is disabled, or the server does not come with Bluetooth.
Description
An error has been detected on the server.
Causes might include one or more of the
following errors:
• The temperature of the server reached
the non-critical temperature threshold.
• The voltage of the server reached the
non-critical voltage threshold.
• A fan has been detected to be running at
low speed.
• The power supply has a critical error.
• The power supply is not connected to
the power.
The server is off or the server is on and is
working correctly.
67.
Action
Check the Event log to determine the exact
cause of the error.
None.