Riso SF Series User Manual page 63

2
Place the paper.
Place the paper in the direction of a short edge
paper feed.
Paper feeding direction
Long side
BUse a standard size of paper. You
cannot use custom size paper or
paper sizes that are registered in
[Admin.].
3
Set the paper receiving tray.
(A 33 "Setting up the paper receiving tray")
4
Touch [Layout] in the [Functions]
tab screen.
5
Touch an original size.
BFor 4-up and 16-up printing,
touch an original size button that
shows a R symbol.
BThe magnification rate is automati-
cally calculated using the selected
original size and the size of the
paper that is placed. If the magnifi-
cation rate is out of the range
between 50 and 200%, the combi-
nation of the original and paper
sizes cannot be used.
6
Touch [Next].
7
Touch the number of copies to be
laid out on a single sheet of paper.
Short side
8
Touch [Next].
9
Set [Original orientation] and [Lay-
out order].
10
Touch [OK].
11
Set the other required printing
conditions.
(A
Chapter 3 Functions for Master Making
BCheck that the original is placed in
the direction shown at the bottom of
the screen.
50 "Functions for Master Making")
BTo cancel [Layout], perform step 4
again and display the setting
screen. Touch [OFF] and then [OK].
61
3