Quantum CHECK POINT 16000 Quick Start Manual page 10

To install the inner appliance rails to the appliance:
1. Place the appliance rail on the side of the appliance and make sure:
The release latch is facing away from the appliance
n
The arrow on the release latch points to the front of the appliance
n
The appliance rail is longer than the appliance
n
2. Install the appliance rails to the side of the appliance with the six provided screws. Refer to the below
appliance rail image.
Note - Do not over-tighten the screws. Check Point recommends that you leave the rail mounting
screws loose until the server is completely installed. This eases installation by preventing binding of
the server in the rack.
3. Do steps 1 and 2 again to install the appliance rail on the other side of the appliance.
Item Description
1 Appliance rail screws
2 Release latch (press this latch to remove the appliance from the rack)
16000, 26000, and 28000 Security Appliances Installing the Telescopic Rails
16000, 26000, and 28000 Appliances Telescopic Rails | 10