Unpacking; Assembly - Fieldmann FDSM 200120-E Manual

7. UNPACKING

Carefully check all parts after unpacking the product from the box.
Do not throw away packaging materials until you have not reviewed carefully if they did not remain a part of
the product.
Parts of the packaging (plastic bags, paper clips, etc.) do not leave within reach of children, could be
a possible source of danger. There is a danger of swallowing or suffocating!
If you notice transport damage or while unpacking, notify your supplier immediately. Do not operate the
product!
We recommend save the package for future use. The packaging materials must still be recycled or disposed
of in compliance with the relevant legislation. Sort different parts of the packaging according to material and
hand it to the appropriate collection sites. For further information contact your local administration.
Fasteners can become loose during transport in the packaging.
Standard accessories are subject to change without notice.
This product requires assembly. The product must be assembled correctly before use.

8. ASSEMBLY

We recommend the cooperation of two persons for the assembly.
STAND
1. Slide a fl at washer on each side of the axle, then the wheel, followed by another washer (FIG. 2A).
2. Insert the pin into the axle holes. Bend the pins so they don't fall out (FIG. 2B).
3. Place the stand on the side and secure the support as shown in Figure (FIG. 3A). Turn the stand and attach
the wheel axle in the same way (FIG. 3B).
4. Check that all nuts and screws are tightened.
BOTTOM OF THE DRUM
1. With the other person's assistance, gently push the bottom of the drum with the axle onto the side supports
of the stand as shown. A longer part of the axle should be on the side of the supporting leg. (FIG. 4A)
2. Align the holes on both sides and insert the M8x65 screws into them. Attach the washer, lock washer and
nut from the other side and tighten using a wrench (FIG. 4B).
TIPPING WHEEL/LEVER
1. Push the locking ring onto the longer end of the drum axle by punching inside as shown in the fi gure. Fasten
with two screws with lock washers and fl at washers. Tighten the nuts (FIG. 5A).
2. Install the M8×25 screw into the tube on the tilting wheel / lever. Insert a washer and spring from the other
side. (FIG. 5B)
3. Attach the tipping wheel/lever to the drum axle (to the longer, protruding end of the axle, on the leg side of
the stand.)
CONCRETE MIXER
17 EN
Unpacking
USER'S MANUAL