Fieldmann FDSM 200120-E Manual page 20

EN 20
Maintenance and storage
Always make sure that all nuts and bolts are fi rmly tightened and make sure the machine is in good working
order.
Keep the machine in good condition, if necessary change warning and instruction labels on the machine.
Always ensure that the ventilation openings are kept clear of debris.
For safety reasons, replace worn or damaged parts. Only use original spare parts and accessories. Parts not
tested and approved by the equipment manufacturer can cause unforeseeable damage.
Repair and maintenance work other than described in this section, which are more complicated, or it needs
special tools, let it on our authorized service.
After drying the mixer lubricate moving parts of the mixer by waterproof vaseline
CLEANING
CAUTION!
Never spray the product with water or expose it to water.
Never use aggressive detergents or solvents for cleaning.
1. Carefully clean the machine after each use.
2. Do not let the handles contaminate with oil or grease. Clean the handle clean with a damp cloth washed in
soapy water. Never use aggressive detergents or solvents for cleaning. This can cause irreparable damage
to the product. The plastic parts can be eaten away by chemicals.
3. Wipe down the product with a slightly damp cloth or with brush.
4. Clean the cover of the machine, especially the ventilation holes.
Thoroughly clean the mixer at the end of each day's operation. Keep your mixer clean. The slightest trace of
material left in the drum will harden and attract more each time you use it until the machine is useless. Dried
cement should be scraped out of the drum. Do not throw bricks into mixer drum to clean it out. Do not beat on the
drum with a shovel, a hammer or other tools to break up accumulations of dried cement mix, as damage to the
mixer may result.
The drum may be scoured for approximate 2 minutes, using 1:1 gravel and water mixture. Then discharge the
gravel/water mixture and hose down the drum assembly inside and out. The IP44D protection class construction
of the concrete mixer enables you to hose down the drum assembly safely.
WARNING!
Do not pour or spray water directly over the motor cover, especially into the
openings in it.
Wipe off any external material on the motor cover. Do not use petrol, turpentine, lacquer or paint thinner, dry
cleaning fl uids or similar products. The use of chemical products or solvents may affect the properties of the
cover which was made of high-density polyethylene PET.
STORAGE
Store the machine out of reach of children.
Turn the motor off and disconnect the mains plug if the machine is not used.
Allow let the machine to cool down before storage.
Do not store the machine a long time in direct sunlight.
FDSM 200120-E