Factory Default Configuration - Banner DX80DR9M-HB1 Manual

Surecross multihop data radio module

Hide thumbs

Table Of Contents

Table of Contents

Outputs

Output # I/O Type

(4xxxx)

501

502

503

Discrete OUT 3

504

Discrete OUT 4

505

Switch Power 1

506

Switch Power 2

Modbus Addressing Convention

All Modbus addresses refer to Modbus holding registers. When writing your own Modbus scripts, use the appropriate commands for

interfacing to holding registers. (Because Modbus numbering begins at 1, users need to subtract 1 from the register address given to

form the numeric value entered into the "address" field of the Modbus RTU protocol command string.) Parameter description headings

refer to addresses in the range of 40000 as is customary with Modbus convention.

Modbus Register Configuration

The factory default settings for the inputs, outputs, and device operations can be changed by the user through the device Modbus regis-

ters.

To change parameters, the data radio network must be set to Modbus mode and the data radio must be assigned a valid Modbus slave

ID.

Generic input or output parameters are grouped together based on the device input or output number: input 1, input 2, output 1 etc.

Operation type specific parameters (discrete, counter, analog 4 to 20 mA) are grouped together based on the I/O type number: analog 1,

analog 2, counter 1, etc. Not all inputs or outputs may be available for all models. To determine which specific I/O is available on your

model, refer to the Modbus Input/Output Register Maps listed in the device's data sheet.

For more information about registers, refer to the MultiHop Product Manual, Banner part number 151317.