Muting Module Configuration - Banner MMD-TA-11B Instruction Manual

MMD-TA-11B / MMD-TA-12B Muting Module
Instruction Manual

3.3 Muting Module Configuration

The Muting Module should be configured before initial checkout
and use. Two banks of DIP switches are located under the front
cover. To access the DIP switches, use a screwdriver to gently
pry the cover loose from the Module housing.
Because the Module has redundant microprocessors, two DIP
switch banks (Bank A and Bank B) must be set identically.
Failure to set Bank A and Bank B identically will result in a
lockout condition. Power must be OFF when changing DIP
switch settings; changing settings while power is ON will cause a
lockout condition. The parameters to be manually configured are
shown in Figure 3-2.
Switch
Bank A
Factory Default Settings
ON
OFF
1 2 3 4 5 6 7 8
NOTE: Switch numbers, e.g. "SW 1," refer to
both switch banks A and B.
Figure 3-2. Muting Module manual configuration parameters
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Auto/Manual
Switch
1 MSSI Reset
Bank B
(See Section 1.3)
Auto/Manual
2 SSI Reset
(See Section 1.3)
One-Way or Two-Way
3 Mute Initiate Sequence
(See Section 1.17)
One-Channel or
4 Two-Channel EDM
(See Section 1.10)
Backdoor Time-Out
5–6
(See Section 1.14)
Monitored/Non-Monitored
7 Mute Lamp
(See Section 1.12)
8 Mute on Power-Up
* Factory default setting
Figure 3-3. Use a screwdriver to gently pry the cover loose
from the Module housing.
Switch ON Position
MSSI auto reset
SSI auto reset
Two-way muting
One-channel EDM
5 ON, 6 ON
No backdoor
time-out (infinite)
5 OFF, 6 ON
60-second backdoor
time-out
Mute lamp not
monitored
Mute on power-up
System Installation System Installation
OFF Position
MSSI manual reset*
SSI manual reset*
One-way muting*
Two-channel or no EDM*
5 ON, 6 OFF
30-minute backdoor
time-out
5 OFF, 6 OFF
30-second backdoor
time-out*
Mute lamp monitored*
No mute on power up*