Atdec AD-AC-PH Installation Manual page 2

1. Attach components to tray
1.1 Mount components on side
of Tray B shown.
Components can be attached
with hook & loop, cable ties,
or the fasteners provided with
your components..
Tip: Use Washers E
when using component
fasteners if needed
2. Choose product configuration then attach bracket
OPTION A - Enclosed components
Components up to 54mm (2 1/8")
high can be enclosed.
Tip: Components can be
mounted on both sides of
tray in enclosed position.
2.1A Position hooks towards
back to make components
accessible when tray
hanging for maintenance.
Enclosed configuration bracket orientation
2.2 Ensure sufficient clearance
to walls/desk structure for
tray attachment and latching.
>40mm
(1.6")
>18mm
(0.7")
Minimum clearance
Hook
>40mm
(1.6")
1.2 Cable exit and entry
always at hinge end.
OPTION B - Exposed components
Components greater than 54mm (2 1/8")
high must be exposed.
54
2.1B Position hooks towards
front to make components
accessible when tray
hanging for maintenance.
>54
Exposed configuration bracket orientation
2.3 Check surface thick enough
and material appropriate for
supplied #10 x 16mm (5/8")
Wood Screws C.
2.4 Use Bracket A as a drilling
template and mark mounting
hole centres.
2.5 Carefully drill 3.5mm (1/8")
pilot holes. Fasten Bracket
with Wood Screws C.
Hinge
Hinge
Hook
Tip: Front and back
tabs with slot detail
are a place to attach
cables independant
of hinging tray
AD-AC-PH Page 2 of 3
54
>54