Power Cord Connection - Baileigh Industrial HSP-110M-HD Operator's Manual

WARNING:
grounded. If you are not sure, have a qualified electrician check the receptacle
 Improper connection of the equipment-grounding conductor can result in risk of electric
shock. The conductor with insulation having an outer surface that is green with or without
yellow stripes is the equipment-grounding conductor. If repair or replacement of the electric
cord or plug is necessary, do not connect the equipment-grounding conductor to a live
terminal.
 Check with a qualified electrician or service personnel if the grounding instructions are not
completely understood, or if in doubt as to whether the tool is properly grounded.
 Repair or replace damaged or worn cord immediately.

Power cord connection:

1. Unwrap the power cord and route the cord away from the machine toward the power supply.
a. Route the power cord so that it will NOT become entangled in the machine in any
way.
b. Route the cord to the power supply is a way that does
NOT create a trip hazard.
2. Connect the power cord to the power supply and check that the
power cord has not been damaged during installation.
3. Once hooked up, turn on the power supply and start the machine.
4. Check that the motor is running in the correct direction.
5. If not, cut the power to the machine. Swap the position of any two
of the three power wires; but DO NOT change the position of the
green grounding wire!
Make certain any receptacle in question is properly
21
21
.