by TITAN
TTB935HTG
Attaching accessories
> Align the required nozzle (8 - 11) with the hot air outlet (1) and attach it. Ensure
Removing/replacing accessories
> After use, let the nozzle cool down before removing it.
> Remove the nozzle (8 - 11) from the hot air outlet (1) and attach a new nozzle
as required.
WARNING! Do not touch the nozzle as it becomes very hot during
use and remains hot for up to 30 minutes after use.
Connection to power supply
> Make sure the on/off switch (4) is in its off position ("0").
> Connect the plug with a suitable socket.
WARNING! Check the voltage! The voltage must comply with the
information on the rating label!
> Your product is now ready to be used.
1
11
10
9
8
Fig. 2
Before you start
EN
17