Programming The Radio - Ebyte E70-DTU User Manual

Hide thumbs Also See for E70-DTU:

Table of Contents

Chengdu Ebyte Electronic Technology Co.,Ltd.

Manual

AT+TLCFG=value

Example:AT+ TLCFG =0 (Attention: This parameter mainly configures the module concurrency performance,

i.e., when multiple nodes concurrently concurrently send data, the maximum number of nodes supported, the

higher the performance, the more the maximum number of concurrency supported by the system, but the delay

in sending data and the average power consumption of the node will increase; the lower the performance, the

node sends the data in real time is very high, but when the environmental interference is large, or multiple nodes

send at the same time, the data may be be lost.)

9. Programming the radio

Working

Modo

Configuration

Mode

Attention:

1 、 Programming can only be carried out in a specific working mode (see the above table), when programming fails,

please make sure the working mode of the radio is correct.

2、If there is no need for complex programming, open the E70-DTU digital transmission radio configuration software

(please visit the official website to download www.ebyte.com ), you can modify the relevant parameters.

Parameter Description:

Value:0~3

0: Low concurrency performance

1: Medium concurrency performance

2: High concurrency performance

3: Very high concurrency performance

OFF

Marginal notes

1. The radio can only be programmed in the current mode

using the configuration software;

2. Or program the radio in any mode using AT commands.

E70-DTU(433NW30) User

Table of Contents

433nw30