Operating Mode; Connection Diagram When Programming - Ebyte E800-DTU V8 Series User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd

6. Operating mode

There are four operating modes, if low power consumption is not required, it is recommended to configure the
data transceiver for the normal mode (mode 0). The factory default is normal mode (mode 0).
Categories
No.
Mode 0 Normal Mode
Wake-up
Mode 1
Mode
Power-saving
Mode 2
Mode
Mode 3 Sleep Mode
Note: no need to care about the wake-up mode (mode 1) and power saving mode (mode 2) if power
★
consumption is not a problem.

7. Connection diagram when programming

Operating
mode
Configuration
Light on
mode
★Note: 1. Programming can only be done in a specific working mode (see the table above). If the programming
Copyright ©2012–2022，Chengdu Ebyte Electronic Technology Co.,Ltd
M0 M1
OFF OFF
ON OFF
OFF ON
ON ON
M1 M0
Light on
Description
Open UART and RF，transparent transmission is on
( factory default )
Transmitting WOR mode, the packet comes with a
preamble code
Receiving WOR mode, saving receive power, the mode
can not be transmitted
Parameter setting using the configuration software
Description
The DTU can only be programmed using the configuration
software in the current mode
E800-DTU(433Lxx-485)-V8 UserManual
9