Ebyte E70-DTU User Manual page 18

Chengdu Ebyte Electronic Technology Co.,Ltd.
Manual
AT+PWCFG Setting/Querying Device Power Parameter Configuration (effective on reboot)
AT+PWCFG=?
13
AT+PWCFG=Value
Example:AT+ PWCFG=3
AT+IOCFG Setting/querying IO port parameter configuration (effective upon reboot)
AT+IOCFG=?
14
AT+IOCFG=Value
Example:AT+IOCFG=0
AT+DFCFG Restore device default parameters
15
AT+DFCFG
Example:AT+DFCFG
AT+RSTART reboot
16
AT+RSTART
Example:AT+RSTART
AT+ECHO Setting the AT command to disable display back
AT+ECHO=Value
17
Example:AT+ECHO=1
Attention: This setting only takes effect on the current boot, and the default setting is restored after reboot to
enable display back by default.
AT+VER Retrieve software version number
18
AT+VER
Example:AT+VER
AT+CLINFO Clear module internal network information
AT+CLINFO
19
Example:AT+CLINFO
Attention: Clear the network after the module can not communicate need to re-establish the network (this
command can user when the coordinator node device number reaches 50, clear all the information)
AT+TLCFG Setup/Query module concurrent performance parameter configuration (effective on reboot)
20
AT+TLCFG=？
Copyright ©2012–2021，Chengdu Ebyte Electronic Technology Co.,Ltd.
Parameter Description:
Get current device power parameter configuration
Response:
PWCFG:3
Parameter Description:
Value:0~3
0：extremely high
1：High
2：Medium
3：Low
Parameter Description:
Get current device IO port parameter configuration
Response:
IOCFG:0
Parameter Description:
Value: 0 or 1
0：Push-pull
1：Open drain
Parameter description: no parameters
Restore device system default parameters
Parameter description: no parameters
Reboot hardware device
Parameter Description:
Value:0 or 1
1：Close the display
0：Open the display back
Parameter Description:
Parameter Description:
Parameter Description:
Get current module concurrent performance parameter configuration
Response:
TLCFG:0
E70-DTU(433NW30) User
18