User-defined parameters can be easily changed without installing a driver. This chapter is a quick introduction to the E70-DTU (433NW30-GPRS) product. It is the easiest hardware environment to test the E70-DTU (433NW30-GPRS) network transmission function, which is to realize the two-way transparent transmission of data from the RF module to the network server.
Page 8
(send New line), the module replies with "Module Restart\r\n" and restarts the module. 2. Open the official E70-DTU (433NW30-GPRS) configuration tool. If the USB is properly connected, the message box on the right will prompt “Device Ready”. Click the “Enter Configuration Status” button in the “Common Commands and Prompts” box. , that is,...
Page 10
(433NW30-GPRS) connection is successful, and the network can be transparently transmitted at this time. 7. The mobile phone pays attention to the “Ebyte Internet of Things Application Expert” WeChat public ID, enter the page, click: Customer Support->Device Test, the screenshot of the mobile phone is as follows: 8.
Page 11
E70-433NWxx, the WORK indicator flashes and the received data is sent to the server. The communication test result as shown below: (a) E70-DTU (433NW30-GPRS) receives the data sent by E70-433NWxx, and then transparently transmits the data to the server.
Chengdu Ebyte Electronic Technology Co.,Ltd E70-DTU (433NW30-GPRS) User Manual (b ) The E70-DTU (433NW30-GPRS) receives the data sent by the server and forwards the data to the E70-433NWxx module. 2.2 Working mode and function The working mode is divided into: communication mode and configuration mode, and the configuration mode is subdivided into 4G/2G network transparent transmission configuration mode and RF configuration mode.
Page 13
LBS information of the device. Query the signal strength of the network module and the base station. Users can use the official E70-DTU (433NW30-GPRS) configuration software. In the 4G/2G network transparent transmission configuration mode, click the “Query Signal Strength” button to get the current signal strength information.
There are two ways to restore the factory: Software recovery from the factory: Users can use the official E70-DTU (433NW30-GPRS) configuration software to reset 4G in the 4G/2G network transparent transmission configuration mode and RF configuration mode by clicking the “Restore Factory” button. 2G module and RF module.