Operating Modes; Coordinator Model - Ebyte E70-DTU User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd.
Manual
Coordinator
A node address
0a 01 aa 45 65 13 12 44
B node address

7. Operating modes

Mode Categories
Coordinator
Mode 0
Mode
Normal
Mode 1
Node
Low Power
Mode 2
Node
Configuratio
Mode 3
n mode

7.1 Coordinator model

If the user-configured system operating mode is 4 and the M0M1 combination is 00 or the user-configured system mode
is 0, the module operates in the coordinator mode. In the coordinator mode, the coordinator can build the network, the
information of the nodes in the network, and it is the center point of the network, and there must be a coordinator present
in the network.
The configurable data input modes for the coordinator are:
Broadcast send: when configured as broadcast send, all non-dormant devices in the whole network receive the data, and
the ACK pin unconditionally indicates that the send is successful.
Short Address Send: When configured as Short Address Send, the user needs to specify the short address of the receiving
device before sending data.
Long Address Send: When configured as Long Address Send, the user needs to specify the long address of the receiving
device before sending data.
Copyright ©2012–2021，Chengdu Ebyte Electronic Technology Co.,Ltd.
Hexadecimal FF FF FF FF FF FF FF FF AA BB CC
Hexadecimal AA BB CC
Hexadecimal AA BB CC
hexadecimal AA BB CC
M1 M0
Build a network and manage the information of the incoming nodes
0 0
(transmit data according to the input and output modes)
0 1 Send and receive data at any moment (high real-time)
Low-power reception, send data at any moment (reception delay,
1 0
send need to wake up the serial port)
Unable to send and receive data, system hibernation, parameter
1 1
configuration (baud rate fixed 115200 8N1)
E70-DTU(433NW30) User
Comments
13