Chengdu Ebyte Electronic Technology Co.,Ltd
Chapter VII: Collection Modes
7.1 The relay is kept all the time
In the acquisition mode, the control state of the relay is always maintained, and the default is that the relay is always maintained.
7.2 The relay holds the set time
It is in the acquisition mode that the control state of the relay is maintained for a certain time, and the holding time can be defined by
itself;
Note: Relay hold time (S) valid values are integers, decimals are invalid;
When the relay control state is 0, its relay is always held, and the relay hold time cannot be set;The relay hold time can only be set
when the relay control state is 1.
Copyright ©2012–2020,Chengdu Yibaite Electronic Technology Co., Ltd
E830-DTU(2R2-433L)-V8 User Manual
14