Listen Address; Operating Mode; Transparent Transmission Mode (Mode 0) - Ebyte E95-DTU User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd.

4.4 listen address

Example: Set the address of radio A to 0xFFFF and the channel to 0x04.
When radio station A is used as the receiver, it can receive all the data under the 0x04 channel to achieve the
purpose of monitoring.

5.Operating mode

E95-DTU has four working modes. When there is no strict low power consumption requirement, and normal
communication is required, it is recommended to configure the radio in the transparent transmission mode (mode
0);The default setting of the radio is transparent transmission mode (mode 0).
number mode
Transparent
Mode 0
mode
Mode 1 WOR mode
Configuration
Mode 2
mode
deep
Mode 3
mode
Note: If there is no need for low power consumption, no need to care about the WOR mode (mode 1).

5.1 Transparent transmission mode (mode 0)

Type When the M0 indicator is off, the M1 indicator is off, and the radio works in mode 0
Transmit Users can input data through the serial port, and the radio will start wireless transmission.
The radio wireless receiving function is turned on, and the wireless data will be output
Receive
through the serial port TXD pin after receiving the wireless data.
Copyright ©2012–2022，Chengdu Ebyte Electronic Technology Co.,Ltd.
M1 M0
Off Off
Off On
On Off
sleep
On On
注释
Serial port open, wireless
transmission (factory default mode), support special
command air configuration.
Can be defined as WOR sender and WOR receiver,
support air wake-up
The user accesses the register through the serial port to
control the working state of the radio, and the user can
configure the radio through the host computer
configuration software.
radio goes to sleep
E95-DTU(900SLxx-485) User Manual
open, transparent