Table of Contents
Advertisement
Chengdu Ebyte Electronic Technology Co.,Ltd.
Ⅳ Operating mode
The E95-DTUs all have four operating modes. For normal communication, you need to configure the radio to the
pass-through mode (Mode 0) by pressing the key, and the radio is set to the pass-through mode (Mode 0) by default
when it is shipped from the factory.
Mode
Type
M1
General
Lights
Mode 0
mode
out
Model
reserved
Lights
1
mode
out
command
lights
Mode2
mode
on
sleep
lights
Mode3
mode
on
4.1 Continuous transmission mode (mode 0)
Type
When M0 = 0 and M1 = 0, the module operates in mode 0
The air rate required for continuous transmission is automatically calculated based on the serial
Tran
port baud rate configured by the user;
smit
The user can input data through the serial port and the module will initiate wireless
ting
transmission.
Rece
ivin
In the non-transmitting state, data can be received normally.
g
In continuous transmission mode, the intuitive experience is that the user does not need to wait for
all the data to be packaged to transmit the data out, but the module starts transmitting from the first
frame of data until the completion of the data that the user needs to transmit. This saves the time of
data packing and packetizing and greatly reduces the data delay
time.
Copyright ©2012–2023，Chengdu Ebyte Electronic Technology Co.,Ltd.
M0
Notice
The
radio
will
calculate the required over-the-air
transmission rate for continuous
Lights
uninterrupted
according to the user-configured
out
serial port baud rate internally,
and the user can just pass in the data
uninterruptedly.
The radio internally enforces the
lights
user-configured
transmission rate. It will transmit
on
in packets at 55 bytes per packet.
The user can access the registers
Lights
through the serial port to control
out
the working status of the radio.
The
radio
will
lights
transmitting or receiving in this
on
mode.
E95-DTU(433Cxx-485)-V2.0 User manual
automatically
transmission
Supports continuous uninterrupted
transmission.
over-the-air
General Transparent Transmission.
Requires configuration at baud rate
9600.
not
do
any
Remark
13
Advertisement
Table of Contents
