Broadcast Address; Listening Address; Operating Mode; Transparent Transmission Mode (Mode 0) - Ebyte E95-DTU433L 485-V8 Series User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd

4.3 Broadcast address

Example: Set the address of DTU A to 0xFFFF and the channel to 0x04.

When DTU A is used as a transmitter (same mode, transparent transmission mode), all receiving DTU under the 0x04 channel

can receive data to achieve the purpose of broadcasting.

4.4 Listening address

Example: Set the address of DTU A to 0xFFFF and the channel to 0x04.

When DTU A is receiving, it can receive all the data under channel 0x04 to achieve the purpose of monitoring.


5. Operating Mode

E95-DTU has four working modes. When there is no demanding low power consumption requirement, it is recommended to configure
the DTU to transparent transmission mode (mode 0) if normal communication is required;
The default setting of the DTU at the factory is transparent transmission mode (mode 0).
No. Type
Transparent
Mode 0 transmission
mode
Mode 1 WOR Mode
Power Saving
Mode 2
Mode
Configuration
Mode 3
Mode

5.1 Transparent transmission mode (mode 0)

Type When the M0 indicator light is off and the M1 indicator light is off, the DTU is working in mode 0
Sending Users can input data through the serial port, and the DTU will start wireless transmission.
The DTU receiving function is turned on, and after receiving the wireless data, it will be output through the
Receiving
serial port TXD pin.
Copyright ©2012–2022，Chengdu Ebyte Electronic Technology Co.,Ltd.
M1 M0
Light Light Serial port open, wireless open, transparent transmission
Off Off (factory default mode)
Light Light
WOR transmission mode, data packet comes with wake-up code
Off On
Light Light WOR receiving mode, saving its own receiving power
On Off consumption, this mode cannot transmit
Light Light
The DTU can be programmed using the configuration software
On On
E95/E96-DTU(433Lxx-485)-V8 User_Manual_EN
Description
10