Pilz PIT es Set10u-5ns Operating Manual page 14

PIT es Set10u-5ns
}
The upper part of the housing can be installed rotated by 180 °. Loosen the 4 screws on
the housing using a TX10 screwdriver with internal serration (XZN) and remove the upper
part of the housing. Rotate the upper part of the housing around the diagonal axis by
180 °. Replace the upper part of the housing on the lower part of the housing and tighten
the screws crosswise with a torque of 0.5 Nm.
Fig.: Housing rotated by 180 °
}
To prevent manipulation, you can affix security labels (min. 19 mm x 7 mm) on the joint of
the housing.
}
To loosen the housing from the mounting plate, you must open the housing. Loosen the 4
screws on the housing using a TX10 screwdriver with internal serration (XZN) and re-
move the upper part of the housing. Then press the release button on the inside on the
base of the lower part of the housing and turn the lower part of the housing by 45 ° to the
left or right.
Operating Manual PIT es Set10u-5ns
1004426-EN-01
NOTICE
In an open state, the electronics contained within the housing are no longer
protected against environmental influences. In particular you should avoid
humidity, electrostatic discharge and the ingress of foreign bodies.
NOTICE
Damage due to electrostatic discharge!
Electrostatic discharge can damage components. Ensure against discharge
before touching the product, e.g. by touching an earthed, conductive sur-
face or by wearing an earthed armband.
| 14