Hanging Method - Hisense Hi-FLEXi S Series Technical, Installation, Maintenance

2.2 Hanging Method

When hanging the unit, ensure a balance of the unit, check to ensure safety and lift up smoothly.
(1) Do not remove any packing materials.
(2) Hang the unit in packaged state with two wire ropes, as shown in Fig.2.1.
Corrugated Paper Frame
Do not remove
corrugated paper frame
and plastic bands
(3) Hang the unit without wooden pallet, as shown in Fig.2.2.
Rope Position
CORRECT
Wire Rope
Circular Hole
INCORRECT
Wire Rope
Square Hole
Do not apply excessive
force (both sides)
In case of transportation after unpacking, protect the unit with the splints or cloth.
Check to ensure that no foreign matters left in the outdoor unit before installation and test run. Otherwise, it may
Wire Rope
Do not apply any
force here.
(both sides)
Wooden Pallet
Carefully guide the sling belts through
both side slots of the wooden pallet.
Fig. 2.1 Hanging Work for Transportation
Corrugated Paper Frame
Do not remove
corrugated paper frame
and plastic bands
Apply wire ropes
through circular holes
Fig.2.2 Hanging Work without Wooden Pallet
lead to a fire, failure or injuries , etc.
Angle of wire rope
greater than 60°
Apply ropes on the splints or
corrugated paper with
thickness greater than
19/32in. (15mm).
Bottom corners: Attach four
cardboard paddings with
thickness 19/32 in. (15mm)
on both sides at this point for
protection.
Wire Rope
Do not apply excessive force on the square holes with forks
or other objects. The bottom of the unit may be deformed.
● Do not push the bottom by fork.
● Do not use roller.
NOTE
75
Transportation and Handling
Greater than 60°
Apply rope on the splints or
corrugated paper with thickness
greater than 19/32in. (15mm)
Do not apply any
forces here.
(both sides)
Bottom corners: Attach four
cardboard paddings with
thickness greater than
19/32 in. (15mm) thick on both
sides at this point for protection.